Jump to content
OMRON Forums

MACRO motor with wild velocity oscillation


Guest DavisG

Recommended Posts

Ran into a new on yesterday. Thanks to Sina for the fix.

 

4 axis system, 16 axis ACC-5E.

 

The motors were showing a 2 kHz (exactly) velocity oscillation (16 kHz phase, 8 kHz servo - oscillation slowed at lower frequencies).

 

Fix: Set Gate2[1].MacroEnable= $1f8000 so that the default value of 0 is not causing it to step on Gate2[0].

 

What was happening - the default value of Gate2[1].MacroEnable = 0 was being interpreted as pointing to Master 0 - which had no feedback. So Gate2[0] read the feedback, then Gate2[1] wrote a 0.

 

So the moral is - make sure that ALL of the Gate2[x].MacroEnable settings are valid, even if you are not using any axes on the gate.

Link to comment
Share on other sites

  • Replies 0
  • Created
  • Last Reply

Popular Days

Guest
This topic is now closed to further replies.

×
×
  • Create New...