KiraYamato Posted October 22, 2011 Share Posted October 22, 2011 Hello, every one I bought a ACC 1P module for my Turbo PAMC 2 Clipper I insert it on Turbo PAMC 2 Clipper the LED D3 turns red and sparkles I found that there is no Connector for the power supply, And I found that it seems to lost a chip on the back side of ACC 1P Is all of your the same? Link to comment Share on other sites More sharing options...
Brian Posted October 24, 2011 Share Posted October 24, 2011 I believe those are test points for the power, and not a place for the connector. Be sure you have inserted the ACC-1P on the headers properly. It is easy to not get all the pins lined up in the socket. Also make sure you have it in the correct orientation. Link to comment Share on other sites More sharing options...
steve.milici Posted October 24, 2011 Share Posted October 24, 2011 The connector for the power supply is not installed as the power is derived from the PMAC this card is connected to. The missing chip you show is the OPT-2 analog input. If you did not order this option it is not installed. Link to comment Share on other sites More sharing options...
Recommended Posts