Jump to content
OMRON Forums

Using GeoBrick LV to drive five phase stepper


wlewis

Recommended Posts

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Posted Images

Guest majidy

Sina recently worked with a customer and I am copying the procedure you need to do:

 

Here is how we can run a 5-phase stepper motor with Geo Brick LV:

 

Setup the amplifier channels 1 and 2 for brushless motors.

Set the phase offset for 360/5=72 degrees: Ix72=410

Setup the microstepping as described in the manual for Geo Brick LV.

Point the Ix83 of motor 2 to the same register as Ix83 of motor 1.

Set Ix75 of motor 1 to 0 and set the Ix75 of motor 2 to 288*Ix71/360 or 52428 for 65536 microstepping described in manual.

Upon initialization, use SETPHASE1,2 command to force the motor 2 to have 288 degrees offset compared with motor 1.

Define both motors as the same axis on PMAC

 

 

Is it possible to use a GeoBrick LV to drive a five phase stepper motor?

 

If so, do you have any details on how to configure the controller for this type of motor?

 

clip_image001.gif.039abf5a6f1e4b4a0c84efac7cc7ff12.gif

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...