Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
switch settings
#1
I have two UMAC crates with a 16-Axis MACRO CPU in each one connected to a VME Ultralite by a fiber ring. I cannot seem to find what the appropriate SW1 and SW2 settings for each of the CPU card in any of the manuals. I currently have SW1=7 SW2=0 for the first macro station card and SW1=7 and SW2=2 for the second macrostation card. I would like all nodes activated.
#2
As page 10 of the MACRO 16 CPU HRM says:
   

So if you want all Servo nodes to be active, set SW1=7. SW2 determines which Master IC# to which to listen.


Forum Jump:


Users browsing this thread: 1 Guest(s)