Jump to content
OMRON Forums

How to enable "c-axis mode"?


Loesch

Recommended Posts

Hi,

how can I enable the "c-axis mode", if PMAC is in "manual work spindle mode"? I assume that's a machine specific problem. "C-axis mode" means I can control the motor through commands, but it's stiff if I try to rotate it manually. "Manual work spindle mode" means, move commands have no effect on the axis/motor, but I can easily rotate the axis by hand. I checked the value of variable Ix00, but it's 1 in "c-axis mode" and 1 in "manual work spindle mode".

According to the TYPE command, I'm using a PMAC Turbo2. PEWIN gives me that:

TYPE

Turbo2, X8

Help is much appreciated.

Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Loesch,

 

The terms "c-axis mode" and "manual work spindle mode" are not terms defined by Delta Tau in Turbo PMAC. These terms are defined by machine integrator and we need more information as far as control modes to be able to assist you. Ix00 is the Servo control register and as long as the motor is being utilized it is set to 1.

 

Regards,

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...