Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ACC-5E
#1
Hi there,

I just got an ACC-5E and want to use it for a couple of things.
Mainly for the handwheel input and for the Display output.

When I put the board into my UMAC chassis and start UMAC configuration software I had expected to see an extra (unidentified maybe) I/O board or an Macro board.
I made sure there where no other boards in the chassis except for the Turbo Pmac and ofcourse the PSU.

Because I do not see any extra boards I think my ACC-5E is broken.

Is there any way to check it further?

Regards from Belgium, Otto.
#2
Hersoft,

Please make sure to issue a "$$$***" command. This will re-initialize the CPU, causing it to detect new hardware on the back plane. Once reinitialized, you can see the ACC-5E. The variable I4902 will show which address Gate2 has been detected on.

Regards,
Sina Sattari
Hardware Engineering Manager
Delta Tau Data Systems, Inc.
#3
Hello Sina,

well I did just that and checked the value of I4902.
It came back wit $0 which can not be true i guess.
I put the card on the first address of the table and I got the Macro chip on it.
Any suggestions now?

regards, Otto.
#4
Hersoft,

Can you post the serial number of your CPU and ACC-5E?

Thanks
Sina Sattari
Hardware Engineering Manager
Delta Tau Data Systems, Inc.
#5
Hello Sina,

Here are the serial numbers.

ACC-5E (603447-101) S/N: C0007EQD

3U-Turbo (603766-104) S/N:C0003VNZ V1.942 5C0 (option)

I tried the ACC-5E also with a different CPU but this did not change the situation.

I hope this helps somewhat.

Regards, Otto.
#6
Hersoft,

Both your cards are new and they will not have any compatibility issue. If you have already tested the ACC-5E with another CPU and got the same result, it indicates a problem with ACC-5E. Please start an RMA process with Delta Tau customer support or through your Delta Tau distributor.

Regards,
Sina Sattari
Hardware Engineering Manager
Delta Tau Data Systems, Inc.


Forum Jump:


Users browsing this thread: 1 Guest(s)