hendraprimasyahputra Posted June 30, 2011 Share Posted June 30, 2011 Hi all, I'm trying to use ACC-51E to read 2D sinusoidal encoder ( LIK2D, made by numerik jena ). I just install the card to the UMAC system with servo IC 4 address $79200. I connect the sensor to the card ( SIN+ SIN- COS+ COS- +5V GND REF+ REF- ). Now i'm trying to set the parameter using turbo setup. But still the card can't read the output from the sensor. So i need guide to set the variables, which variable i should consider ? Link to comment Share on other sites More sharing options...
Omron Forums Support Posted June 30, 2011 Share Posted June 30, 2011 Pages 19-24 of the ACC-51E manual describes in detail the I-Variables you need to configure to make the card work. Link to comment Share on other sites More sharing options...
hendraprimasyahputra Posted June 30, 2011 Author Share Posted June 30, 2011 Pages 19-24 of the ACC-51E manual describes in detail the I-Variables you need to configure to make the card work. For example, right now i have sinusoidal encoder with grating pitch 20 micrometer. After interpolation i can't calculate the resolution of my sensor. Is that correct if i just do 20/4096 as my new resolution ? Link to comment Share on other sites More sharing options...
Recommended Posts