Jump to content
OMRON Forums

ACC-72E CAN/Profibus


hongchinlin_992x

Recommended Posts

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

ACC-72E uses different Hilscher modules for different protocols. Here is a list of Hilscher modules which are being used on ACC-72E:

 

Module       Fieldbus 
-----------  -----------------
COM-DPM      Profibus Master
COM-DPS      Profibus Slave
COM-CA-DNM   DeviceNet Master
COM-CA-DNS   DeviceNet Slave
COM-COM      CanOpen Master
COM-COS      CanOpen Slave
COM-CNS      ControlNet Slave
COM-CN-CCS   CC-Link Slave

 

 

Link to comment
Share on other sites

  • 2 months later...

ACC-72E uses different Hilscher modules for different protocols. Here is a list of Hilscher modules which are being used on ACC-72E:

 

Module       Fieldbus 
-----------  -----------------
COM-DPM      Profibus Master
COM-DPS      Profibus Slave
COM-CA-DNM   DeviceNet Master
COM-CA-DNS   DeviceNet Slave
COM-COM      CanOpen Master
COM-COS      CanOpen Slave
COM-CNS      ControlNet Slave
COM-CN-CCS   CC-Link Slave

 

 

 

 

Can any of the CanOpen versions be used to run raw CanBus communications or does the CanOpen layer have to be included?

 

Link to comment
Share on other sites

pennells,

 

We use Hilscher modules for these boards. The memory on these modules act as a Dual Ported RAM to PMAC and all the other communication requirements are done by Hilscher module. If you need detailed information, you need to contact Hilscher.

 

Regards,

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...