Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
START command
#1
In a PLC I use start1:1.000001 to start program1 from line label1. But it always starts at the start or the program. What is the proper syntax of the start command to start program1 in CS1 from line label1?
Reply
#2
brad Wrote:In a PLC I use start1:1.000001 to start program1 from line label1. But it always starts at the start or the program. What is the proper syntax of the start command to start program1 in CS1 from line label1?

The syntax is correct but a firmware bug stopped it from working. Use firmware dated after August 25th 2008
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)