Jump to content
OMRON Forums

Using Powerbrick Output as TrueDac type Coordinate


bprall

Recommended Posts

I have a powerbrick system with several unused outputs. I was wondering if any of those outputs could be configured to act as a feedback free coordinate linked to the voltage output. Essentially it would be an Analog Out type channel that can be linked to a coordinate for the motion control. It was not clear to me if this would be possible as this is a PWM type controller/amplifier combination.

 

I also have an AX1515N which I am interested in doing a similar thing. It seemed somewhat more likely to be possible with this device.

Link to comment
Share on other sites

  • Replies 5
  • Created
  • Last Reply

Top Posters In This Topic

For “True DAC” in the Power Brick you will need manual setup either in the IDE as a custom configuration file or as Global Includes.

 

For setup of the AX1515N on a CK3M, use the IDE’s automatic setup. This is described in the motor setup section of the IDE manual.

 

Make sure to use the latest IDE version:

https://assets.omron.com/m/44d71092a258bcde/original/PMAC-IDE-4-5-2-9-Nov-2021.zip

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...