Jump to content
OMRON Forums

Auto-correcting interpolator


Raghav

Recommended Posts

Dear ODT team,

We have placed an order for 4+2 ACC24-E3 card and we see an unprecedented delay for this card for last 8 months. Kindly let me know any chances of getting them sooner.

 

Alternatively, I need to check if I can use a ACC51E high resolution interpolation card for the Analog encoder interpolation? Does this card comes with gate 3 type of auto-correction option in it? If so, can I use ACC51E instead of ACC24-E3 for the encoder feedback? Kindly advice as we are over run on the timeline badly.

 

Regards,

Raghav

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

"Kindly let me know any chances of getting them sooner."

I would contact the local sales channel for order status.

 

The ACC-51E does NOT use Gate3, it is Gate1.But technically, yes, you can use it for sine/cosine analog encoder input.

It's interpolation is x4095 as opposed to the standard x16384 with ACC-24E3 or x65536 with ACC-24E3 ACI option. This should be taken into consideration configuring the encoder/motor.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...