Jump to content
OMRON Forums

Why are the pole-zero frequencies obtained by the notch filter calculator different


shane

Recommended Posts

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

Hi Eric,

My IDE version is 4.3.0.107

 

From the image,my system's resonant frequency is 700Hz, but The Notch filter's Lightly Damped Zero Frequency and Heavily Damped Pole Frequency are not 700Hz.

It seemed Lightly Damped Zero Frequency = 0.9 * Resonant Frequency ; Heavily Damped Pole Frequency = 1.45 * Resonant Frequency ;

 

Generally,for a notch filter, the numerator and denominator frequencies will be set same with resonant frequency; but in IDE , they are different .

Link to comment
Share on other sites

Having the zeros at 90% of the resonant frequency provides more phase lead for stability. Having the poles at 150%, reduces the high-frequency gain and so noise magnification. If you want, you can bypass these automatic values and specify frequencies and damping ratios for both zeros and poles directly.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...