Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to send“$$$”in plc program
#1
When Ecat[0].enable=0, the IO data still exists in the cache. I need to send "$$$" in the IED terminal to clear the data.
I added " CMD"$$$" " in plc, but it didn't work. How to reset the POWER PMAC control in the plc program?
Reply
#2
Power PMAC FW does not allow the “command processor parsing” of the following commands in script programming for safety reasons:
Save
$$$***
$$$

You could “reboot” Linux in a program as follows (like a power cycle reset):
p1=sprintf(256, "reboot")
system "%s", 256
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)