Jump to content
OMRON Forums

MACRO Ring issue (MacroMode)


sdefisher

Recommended Posts

I've been troubleshooting a weird motion problem that seems to go away if is reset the CNC controller ($$$). I generated a config before and after a reset to detect parameter differences. The only difference I found was as follows

 

Before (problem)

Acc5E[0].MacroMode=$4073

 

After (working fine)

Acc5E[0].MacroMode=$4070

 

According to the manual, it seems that I have "Data Overrun Error" and "Byte Violation Error" on my MACRO ring. Is there a way to clear this without rebooting? Any ideas how I am triggering such a fault?

 

Note:

Other MACRO settings I currently have set.

Macro.TestPeriod=40

Macro.TestReqdSynchs=36

Macro.TestMaxErrors=4

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • 2 weeks later...
Guest
This topic is now closed to further replies.

×
×
  • Create New...