Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repeatable IDE crash when adding similar name variables.
#1
I have been creating a new application and ran into a problem when defining global variables. If I type in the name of a variable that is already defined the IDE closes and reopens and I loose everything from my last save until that point. I can work around it and have started typing my variables up in notepad++ and pasting them over.

Has anyone else experienced this. Say I am creating similar arrays and I just want to append something to the end like below

global solution_east(11)
global solution_east_is_trash(11)

as soon as I type global solution_east again under the original variable the IDE crashes.

it also happens if i copy and paste the same variable. I do this regularly and maybe change the last digit or something like that. Maybe it is specific to this project I'm working inside? It's probably an intellisense thing.
Reply
#2
This is a known issue with IDE 4.4.0.99. I have seen (remotely) that the issue is fixed in the current builds so it will be fixed in the next IDE release.

For now, if it bugs you too much, I would revert back to IDE 4.3.2.19.
https://automation.omron.com/en/us/produ...PMAC%20IDE
Reply
#3
Not a deal breaker. I just figured out I can just type it all in and omit the global prefix and then just ALT-SELECT and paste global to the beginning of the lines and it works fine.

Thanks for the feedback.
Reply
#4
This problem occurs only in the global include folder.
So now I am working on the PLC PROGRAM folder...
Reply
#5
This issue is fixed in Power PMAC IDE v4.4.1.7 which is now available on the Omron Website through the "Power PMAC IDE Download" link.
https://automation.omron.com/en/us/produ...pmac%20ide
Reply
#6
(10-13-2020, 10:41 AM)Eric Hotchkiss Wrote: This issue is fixed in Power PMAC IDE v4.4.1.7 which is now available on the Omron Website through the "Power PMAC IDE Download" link.
https://automation.omron.com/en/us/produ...pmac%20ide

AccessDeniedRequest has expired216002020-10-13T17:42:49Z2020-10-13T18:27:27Z8112E3603E6799EFzJ0cvyibWlBXam42qstOxduzGAFEqKeTc2orcMfTvUCXiovhkYRAUzVtOwcGK5d4eNUmIcw1CzU=
Reply
#7
Jeff,

Can you give it a bit and try again? We've seen that before and are trying to figure out a cause, but in the meantime, it seems a bit inconsistent and goes away on its own after a bit.
Reply
#8
(10-13-2020, 10:41 AM)Eric Hotchkiss Wrote: This issue is fixed in Power PMAC IDE v4.4.1.7 which is now available on the Omron Website through the "Power PMAC IDE Download" link.
https://automation.omron.com/en/us/produ...pmac%20ide

Thank you Eric.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)