Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Safety relay of GeoMacro Drive

I would like to ask if there is a way to monitor the status of the Safety relay of the GeoMACRO Drive by software (e.g. M-variable)
There is no “software status” for the action of the Safety Relay. You could “monitor” the relay contact through an input but depending on how it is used, this may require “extra” electronics.

Forum Jump:

Users browsing this thread: 1 Guest(s)