IDE Tune tool get stuck after 5 minutes working

[jnasri]

Hi everebody,

I am using power pmac IDE 43.2.19 with powerbrick LV (CPU:PowerPC,460EX / frimware 2.3..2.5) on a windows 10 Pro 64 bit.

I have a problem with the Tuning tool which get stuck after 5 to 10 successfull sine or trapezoidal or even step curves profile generation.

it is impossible to exit neither tune tool nor the IDE itself when it get stuck. i have to stop it via the windows task manager.

the problem is occuring every time i launch the tune tool.

please help!

[Eric Hotchkiss]

There is a known issue where if you change a gain and don't click out of the box before running the tuning move, the window has a small chance of crashing. Do you think this could be your issue?

I know some changes to the tune tool are coming that will address this issue.

[Tony]

The problem Eric described happens almost every time I forget to click out of the box on my laptop. It makes tuning a frustrating experience because it is very easy to forget. The bug is still present in V4.4.0.99.

[jnasri]

(08-21-2020, 08:59 AM)Eric Hotchkiss Wrote: There is a known issue where if you change a gain and don't click out of the box before running the tuning move, the window has a small chance of crashing. Do you think this could be your issue?

I know some changes to the tune tool are coming that will address this issue.

Thank you for your reply. I am not sure that it is the case. I will follow your instruction on clicking outside the box and make you informed if it does stop crashing.

[Sanjay]

FYI - This problem still exists in Version 4.4.1.7 (latest one). Extremely annoying to have to restart whole IDE each time.