Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wrong Format of master XML (errcode 0x9811001B)
#1
I am setting up 6 Sanyo Denki Series 3 drives to CK3E controller. The XML files have been loaded to the IDE. As I add the drives to the project and scan ethercat network I get the above error. I tried changing firmware on drives but the error remains. The project is correct as works fine on another system. Trying to create an identical system this error message persists. Can anyone advise please?
Reply
#2
Since it sounds like you have two identical systems and one works correctly, can you show the response both give when "ecat slaves" is entered into the terminal? I want to see if everything is the same revision.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)