Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PowerPMAC Clipper APM86xx freezes
#1
Hello!
I have a problem with the controller Clipper APM86xx freezing.
I am using Power PMAC-NC 8 axes. In manual mode, everything works well.
In Auto and MDI mode, when starting on the G0X100Z-100 frame, the controller starts moving and freezes (stops working).
It starts to work after a full reboot.
What could be?

Сontroller configuration 8 axis .
ACC-8FS -2 boards
ACC-24S3-1 board
Thanks in advance for your help.


Attached Files Image(s)
                   
Reply
#2
Hello!
I figured out the problem. The problem is firmware 2.4.0.180.
When I replaced the controller with a new one, everything worked with firmware 2.5.0.4 . I updated PowerPMAС to version 2.5.0.4 and it worked.
I upgraded PowerPMAK to version 2.5.0.4 and it worked. Where can I get the latest update for CPU 465(Clipper)?
Thank you!
Andrey.
Reply
#3
This would be a technical support issue.
Please contact ODT's technical support at:
ODT-Support@omron.com
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)