Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Acc-24E3 ACI guidance on Velocity signal
The ACI is capable of generating a high quality velocity signal, but the hardware manual talks a lot about scaling and such. Is there some simple guidance to setting these and treatment through an encoder table entry for using this feature?
Side note: we use the registers these signals come through during setup to match the magnitude and offset of the sine/cosine signals so need to be able to switch between the standard differential derived velocity and the one generated by the ACI.

Forum Jump:

Users browsing this thread: 1 Guest(s)