Jump to content
OMRON Forums

Background Reporting


jbeasley

Recommended Posts

I am reworking an application I wrote that pulls data from DPRAM on a Turbo PMAC 2 using the GETMEM ethernet protocol and displays the axis data on a PC.

 

Currently I have a PLC that populates M-VAR's that point to User DPR and I pulled those bytes down. I was working with the Background Motor reporting feature and ran into an issue with the Following Error.

 

For clarification I created a following error that is exactly the same as the master position so i could compare the bytes in the DPR viewer and i'm not sure why they show FF? I attached a picture to show what i'm seeing.

 

The MSbyte @ offset 0x0074 is FF when it should be 0C?

 

The reporting works fine on the Master Position. @ offset 0x009C you can see it is $0C99

 

It is odd because i was doing #1j:1000 and it seems to work at some points and then add's the FF at others then goes back to a correct reading on the next #1j:1000? I'm sure there is something i'm missing but I was hoping for clarification?

 

Thank You.

462205643_FollowingErrorREporting.thumb.PNG.5ed8f228530a418adafede2fb85f41b8.PNG

Link to comment
Share on other sites

  • Replies 0
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Posted Images

Guest
This topic is now closed to further replies.

×
×
  • Create New...