Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Background Reporting
#1
I am reworking an application I wrote that pulls data from DPRAM on a Turbo PMAC 2 using the GETMEM ethernet protocol and displays the axis data on a PC.

Currently I have a PLC that populates M-VAR's that point to User DPR and I pulled those bytes down. I was working with the Background Motor reporting feature and ran into an issue with the Following Error.

For clarification I created a following error that is exactly the same as the master position so i could compare the bytes in the DPR viewer and i'm not sure why they show FF? I attached a picture to show what i'm seeing.

The MSbyte @ offset 0x0074 is FF when it should be 0C?

The reporting works fine on the Master Position. @ offset 0x009C you can see it is $0C99

It is odd because i was doing #1j:1000 and it seems to work at some points and then add's the FF at others then goes back to a correct reading on the next #1j:1000? I'm sure there is something i'm missing but I was hoping for clarification?

Thank You.


Attached Files Image(s)
   
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)