Jump to content
OMRON Forums

plot upload fail


Kit Richrds

Recommended Posts

I'm trying to use the plot feature of the PPMAC IDE. The gather button seems to work but the upload button never finishes. I have a very simple setup sampling motor 8 actpos, despos, iqcmd, processing motor 8 cmd position, following error. Plotting following error on left axis, cmd position on right axis. Max gather samples 10, sample period 10. The window says Legacy Mode in the lower left corner.

 

Any ideas why it is unable to upload the sampled data?

 

Thanks!

IDEPlot.jpg.f226da5cdea7ab023be5779176e65bf8.jpg

Link to comment
Share on other sites

  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

What are your IDE and firmware versions? Has plotting in general worked for you on this IDE install and PMAC previously? Have either version changed recently?

 

Normally as long as the IDE and firmware versions are from near the same time, there is no need for legacy mode at all, so they might be too far apart.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...