Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RESOLVED - Decreasing AdcAmpClockDiv produces I2T fault
#1
Hi,
I wanted to try increasing the sampling frequency of the adc input. So I set the parameter Gate3[0].AdcAmpClockDiv from 4 to 3. But when I do that I instantly get an I2T and an AmpFault upon downloading the project. Is there any explanation for this or has anyone who experienced the same problem?
Best regards,
hannsx
Reply
#2
What amplifier is this?
Reply
#3
(08-06-2019, 03:56 PM)steve.milici Wrote: What amplifier is this?

I use the PowerBrickLV with 5/15A on 1-4 and 1/3A on 5-8. The Amplifier is the acc-59e3 as far as I know. I am using channel no. 6, with 1/3A.
Reply
#4
The ADC clocking in this product is fixed in hardware and should not be changed from the default.
Reply
#5
(08-07-2019, 09:32 AM)steve.milici Wrote: The ADC clocking in this product is fixed in hardware and should not be changed from the default.

Ah, ok. Is that written in the PowerBrickLV manual?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)