Jump to content
OMRON Forums

Feed override with Coord[x].SegOverrride


ulhasfegade

Recommended Posts

Currently we are using feed override with Coord[1].DesTimeBase . However this shows some issue like sluggish during acceleration and deceleration. Hence we like to use Coord[1].SegOverrride . We have tested this and it works perfectly with G01, G02, G03 commands. However it does not work with Rapid traverse. Can you suggest some way of implementation that it works for rapid as well.
Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Also, some users will want one or more attributes of the linear move mode when they are executing what would normally be “rapid” mode moves as in the Ability to use the same “segmentation override” as for linear and circle mode moves.

 

See the section “Using Linear Mode for “Rapid” Moves” in the “Power PMAC User’s Manual” starting on page 702 (703 electronic).

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...