Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cout in plc
#1
Dear Sir,

I am using Ethercat Motor with CK3m,

and #1out10, #1out20,..#1out30 these commands are issuing from terminal window is working fine,

my query is to issue this with through PLC , as per manual,

local ctr=10;

cout1: (ctr);

this command is not working.

when i tried with cout1:10; this command working fine.

guide to for indirect address.

regards
Gururaj
Reply
#2
We cannot duplicate this here. Are you sure your local variable retains the value you intended for it?

From outside the PLC, you can query its local variable values with PLC[i].Ldata.L[n]

Does it work for you with a global variable? cout1:(P1)
Reply
#3
(05-17-2019, 11:15 AM)curtwilson Wrote: We cannot duplicate this here. Are you sure your local variable retains the value you intended for it?

From outside the PLC, you can query its local variable values with PLC[i].Ldata.L[n]

Does it work for you with a global variable? cout1:(P1)

from global variable also it is not working.
Reply
#4
This would be a technical support issue.
Please contact ODT's technical support at:
ODT-Support@omron.com
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)