Jump to content
OMRON Forums

460EX watchdog


JeffLowe

Recommended Posts

I note that the 460EX uses the same LBA716 Dual Single-Pole OptoMOS relay as the ACC24E3. Does it have a similar design problem with an improperly sized driver gate or the excessive current due to a undersized resistor? We have had some faults with this relay.
Link to comment
Share on other sites

  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

There have been no reports of issues with the WD circuit on this CPU. It has been in production since 2008.

 

Yet again, there were no reported problems with the ACC24E3 amp enable circuit either, but the ECO process on that one is a major headache for us right now. The CPU uses the same opto relay and I just was hoping someone could look at the schematic and verify if the same driver nand gate was used and/or the same pullup. I am just hoping we can be proactive.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...