ACC-5E with Power PMAC and Turbo PMAC

[dholden]

I have an ACC-5E that was working fine with a Power PMAC but when i try to use it with a Turbo PMAC it does not accept configuration.

Specifically when using the card in a rack system with a Trubo PMAC i cannot set any of the MACRO variables, for example:

I6800=6527
I6802=3
I6840=$4030
I6890=$90

etc...

When setting a value to these variables they simply return to a value of zero.

Any idea why this would be the case?
is there a difference between the Power PMAC card vs the Turbo PMAC card?
Are there jumpers that need to be changed

Any Ideas or suggestions would be appreciated

Thanks

[steve.milici]

Verify the card is addresses as the first MACRO IC. Also verify there is no other MACRO IC card at this address.

[dholden]

S1 Dipswitch are all set to "on"
This should make the base channel address $78400 (MARCO IC 0)

This is the only other card in the rack right now (with the Turbo PMAC CPU) to help with troubleshooting

Also, I can confirm that J1 jumper pins 1-2. I am using fiber for MACRO not the RJ45 connectors.

[steve.milici]

This would be a technical support issue.
Please contact ODT's technical support at:
support@deltatau.com