Jump to content
OMRON Forums

ACC-5E with Power PMAC and Turbo PMAC


dholden

Recommended Posts

I have an ACC-5E that was working fine with a Power PMAC but when i try to use it with a Turbo PMAC it does not accept configuration.

 

Specifically when using the card in a rack system with a Trubo PMAC i cannot set any of the MACRO variables, for example:

 

I6800=6527

I6802=3

I6840=$4030

I6890=$90

 

etc...

 

When setting a value to these variables they simply return to a value of zero.

 

Any idea why this would be the case?

is there a difference between the Power PMAC card vs the Turbo PMAC card?

Are there jumpers that need to be changed

 

Any Ideas or suggestions would be appreciated

 

Thanks

Link to comment
Share on other sites

  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

S1 Dipswitch are all set to "on"

This should make the base channel address $78400 (MARCO IC 0)

 

This is the only other card in the rack right now (with the Turbo PMAC CPU) to help with troubleshooting

 

Also, I can confirm that J1 jumper pins 1-2. I am using fiber for MACRO not the RJ45 connectors.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...