Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GEO BRICK IP addressing change
HI there

we replaced new GEO brick controller and trying to setup the IP address as procedure that downloaded from previous Q&A .
however the procedure did not work this time and pop up an message tells "cannot write to EEPROM ." while pressing the boot sw and store IP

Is this something wrong with the controller ? or EEPROM write protect are enabled somehow ?

Attached Files Image(s)
This would be a technical support issue.
Please contact ODT's technical support at:

Forum Jump:

Users browsing this thread: 1 Guest(s)