Jump to content
OMRON Forums

GEO BRICK IP addressing change


eric lai

Recommended Posts

HI there

 

we replaced new GEO brick controller and trying to setup the IP address as procedure that downloaded from previous Q&A .

however the procedure did not work this time and pop up an message tells "cannot write to EEPROM ." while pressing the boot sw and store IP

 

Is this something wrong with the controller ? or EEPROM write protect are enabled somehow ?

750271937_cannotwritetoEEPROM.thumb.png.c341d358a53101b751a314dba05e3f3d.png

Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Posted Images

Guest
This topic is now closed to further replies.

×
×
  • Create New...