04-03-2019, 02:43 AM
HI there
we replaced new GEO brick controller and trying to setup the IP address as procedure that downloaded from previous Q&A .
however the procedure did not work this time and pop up an message tells "cannot write to EEPROM ." while pressing the boot sw and store IP
Is this something wrong with the controller ? or EEPROM write protect are enabled somehow ?
we replaced new GEO brick controller and trying to setup the IP address as procedure that downloaded from previous Q&A .
however the procedure did not work this time and pop up an message tells "cannot write to EEPROM ." while pressing the boot sw and store IP
Is this something wrong with the controller ? or EEPROM write protect are enabled somehow ?