Jump to content
OMRON Forums

Primary Feedback is none


linda618

Recommended Posts

Hi,everyone,i met a question when i added a motor to a slave device. After had configured "Amplifier","User Units",I found that the Primary Feedback of the Feedback Type in Encoder is none but i had downloaded the project and "Load Mapping to PowerPMAC".I had no idea about it.Is the hardware is not compatible?Or something wrong with esi?Or the others?And can i do something about it?Thanks
Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Hi,everyone,i met a question when i added a motor to a slave device. After had configured "Amplifier","User Units",I found that the Primary Feedback of the Feedback Type in Encoder is none but i had downloaded the project and "Load Mapping to PowerPMAC".I had no idea about it.Is the hardware is not compatible?Or something wrong with esi?Or the others?And can i do something about it?Thanks

Maybe the modle in your PPMAC library is different from the one actually connected. So, delete it after selecting the amplifier and do it again.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...