Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Primary Feedback is none
#1
Hi,everyone,i met a question when i added a motor to a slave device. After had configured "Amplifier","User Units",I found that the Primary Feedback of the Feedback Type in Encoder is none but i had downloaded the project and "Load Mapping to PowerPMAC".I had no idea about it.Is the hardware is not compatible?Or something wrong with esi?Or the others?And can i do something about it?Thanks
Reply
#2
(01-24-2019, 11:01 PM)linda618 Wrote: Hi,everyone,i met a question when i added a motor to a slave device. After had configured "Amplifier","User Units",I found that the Primary Feedback of the Feedback Type in Encoder is none but i had downloaded the project and "Load Mapping to PowerPMAC".I had no idea about it.Is the hardware is not compatible?Or something wrong with esi?Or the others?And can i do something about it?Thanks
Maybe the modle in your PPMAC library is different from the one actually connected. So, delete it after selecting the amplifier and do it again.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)