Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
stop on hardware limit
#1
hello,everyone,I had a question about hardware limit.When motor hitting one of the hardware limit,it stopped very slowly and had a large follow error just liked stopped by "kill" mode.But i am sure Motor[x].FaultMode=0.When i had a "Jog" move,"j/" worked well by setting Motor[x].AbortTa=100
Reply
#2
Check to see if the motor is killed. There should be no FE when killed.

Make certain Motor[x].AbortTa and Motor[x].AbortTs are not set so aggressively as to cause a fatal following error.

Note that "j/" uses Motor[x].JogTa and Motor[x].JogTs not Motor[x].AbortTa and Motor[x].AbortTs .
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)