Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Saving configuration in MACRO CPU
#1
We have a recently purchased 8 Axis MACRO CPU that is not saving all the configuration values.

Most values are saved, but the ms0,mi112 and ms0,mi113 values used for setting the power-up position source address are not saved by the 'mssave 0' command. These need to be set manually each time we reset the UMAC MACRO chassis.

UMAC MACRO CPU Firmware version: 1.120
UMAC MACRO CPU Firmware date: 03/27/17

PowerPMAC CPU firmware version: 2.0.2.14

IDE version: 4.1.0.24
Reply
#2
Contact the support group with the board's s/n:
support@deltatau.com.

These should be getting saved.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)