Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Run-time error codes like in Turbo PMAC
#1
Hi!
In case of run-time error Turbo PMAC provided run-time error codes (Y:$002x14) !
Does Power PMAC also provide such informations?!
Thanks,
Anton
Reply
#2
Yes - see "Coord[x].ErrorStatus" for bit (bit 16) details in the SRM.
Reply
#3
Hi Stephen!

On Turbo PMAC there was a real run-time error status-word with a bunch of bits telling the cause of any run-time error:

= 1: Insufficient calculation time
= 2: Program counter out of range (too low)
= 3: Program counter out of range (too high)
= 4: Unlinked conditional statement
= 5: Subroutine stack overflow
= 6: Jump to non-existent label
= 7: Cutter compensation interference error
= 8: Forward kinematic execution error
= 9: Inverse kinematic execution error
= 10: No axes remaining in C.S.

On PPMAC there is only that one and only bit 16 in Coord[x].ErrorStatus - nothing else more anymore.
Or am I missing up something?!

Regards, Anton
Reply
#4
Coord[x].Ldata.Status has that information.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)