Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ILC not working
#1
Hi!
I am trying to set up torque-compensation.
The Setup-tool shows "LC Setup" but in there I cannot setup/start anything!!?
I am using IDE V3.0.1.0 and V4.1.0.24

See pic

Any idea?
Thanks, Anton


Attached Files Image(s)
   
Reply
#2
Send your table setup to support and we'll try it here. in the mean-time I will make my own test.
Reply
#3
(08-30-2018, 11:52 AM)steve.milici Wrote: Send your table setup to support and we'll try it here. in the mean-time I will make my own test.

Meanwhile I could manage to get it to run. I did not properly set up CompTable (using "Compensation Table" in IDE-DeltaTau). For now everything seems to work fine.
Thanks nethertheless
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)