Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DAC Glitch on Acc24E3
#1
Acc24E3 with 18 bit DACs. Non-commutated torque mode motor, Phase =16, servo =8 KHz.
We are experiencing a 2.5 Volt, 62.5 usec wide glitch. This can be captured with an oscilloscope, but Gather of Gate3[0].Chan[3].Dac[0] does not show the glitch, only the aftermath (Ringing in following error and the proper servo response to it). Can this be the result of clock settings, and If so, what are the recommendations?
Reply
#2
I wouldn't expect Phase/Servo clocks to be an issue. See if reducing Gate3[i].DacClockDiv by one tick helps. If you continue to have this issue contact support@deltatau.com with the oscilloscope plots.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)