Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor unactivated after reset
#1
Hello everyone,

I am trying the new firmware 2.4.0.180 for PowerBrick LV and new PowerPMAC IDE 4.0.3.0.

Somehow after launching "save" command and "$$$" command. My motors become unactivated. I had a look at the file "pp_save.cfg". Suprisingly, it didn't save some variables e.g. Motor[x].ServoCtrl or Motor[x].PowerOnMode even though I am sure that I had set it up in my header files in Global Includes folder and downloaded all of them.

Is it the new feature of firmware or IDE?
Does anyone have any idea?
Reply
#2
This is probably specific to vs 4 of the IDE.

Please contact the Support Group with a copy of your project at:
support@deltatau.com.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)