Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to add 2 axes to a PowerPmacNc16-SDK project
#1
Hello.
How to add 2 axes to the PowerPmacNc16-SDK project, the B-axis (circular) and the W-axis (axis built-in to the spindle), and change the subprog ComputeNCTransform?
Reply
#2
In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project.
Reply
#3
(04-27-2018, 02:06 PM)vinceb Wrote: In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project.
my username on GitHub AndreyErsted. My mail: Andrey.krasnynsky@gmail.com.

Thanks, I'll wait.
Andrey.
Reply
#4
(04-27-2018, 02:06 PM)vinceb Wrote: In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project.
Hello!
How to get an example ?
Best regards.
Andrey.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)