Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PMAC Turbo Clipper diagram showing connector labels
#1
Trying to do some layout design for a Clipper (16 weeks till I see it). There is a diagram showing mounting holds in the on-line docs.

Is there a version of that diagram calling out the J1, J2....J9 connectors?

At the very least, two 34 pin connectors , which is J4, J9?
Reply
#2
See the attached image--it should show where all of the connectors are.

For the specific two you mentioned, J9 is in the bottom right by the USB port and J4 is in the bottom left by the serial port.


Attached Files Image(s)
   
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)