bladeoface Posted February 2, 2018 Share Posted February 2, 2018 Hi, I'm currently experiencing a problem on two of my power clipper boards. 8 and 16 axis. They both have the appropriate +5 V DC being fed into them but they are not communicating. The LED status is as follows: D10: Green D12: Nothing D15: Nothing (Should be amber colored) Does anyone know how to remedy this start-up problem? Link to comment Share on other sites More sharing options...
steve.milici Posted February 2, 2018 Share Posted February 2, 2018 This would indicate the PMAC or Linux is not booting. Record the boot response from the serial port and contact support@deltatau.com with the results. Link to comment Share on other sites More sharing options...
Recommended Posts