Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Resetting Mxx67 after changing Ixx06
#1
Hi,
Just wondering the best way to clear an axis handwheel offset if setting the input to the master to zero didn't work.

Usual Method (axis 3):
We override a motion path by enabling master following I306=3 and then inputting an offset into the address defined by I305. (This goes through an exponential filter in ECT). To clear the offset we usually set the offset input to 0 which moves M367 back to 0.

Problems (crash):
There are times that setting the input to the filter to 0 doesn't totally clear M367. Therefore the present master position has an offset. What is the best way to get rid of the offset in M367?
I tried to turn off following I306=0, then #3PMATCH, then write M367=0 which caused the axis move very fast but it clears it. I won't to avoid this rapid movement but totally clear the present master position. What is the recommended approach.

Thanks
Matt



Thanks
Matt
Reply
#2
#3HMZ should work.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)