Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PLCC 56k maximum memory exceeded
#1
hello, There is a problem when I download my servo program
Error:1:PLCC Err:PLCC 56k maximum memory exceeded
How to fix it up?
Reply
#2
Sounds like either it is being attempted to download PLCC programs for a PMAC with extra memory into a PMAC with smaller memory, or PLCC programs have been increased too much in size; therefore, the solution is to either reduce the size of PLCC programs or, if possible, increase the size of PMAC memory. For instance, the UMAC CPU can have either 128Kx24 or 512Kx24 for compiled/assembled program memory.
Reply
#3
Thank you I will do it again.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)