MattReid Posted April 20, 2017 Share Posted April 20, 2017 Hi I have a GeoMACRO Drive connected to a GEOBRICK as the MACRO Master. Everything was working fine and MACRO was setup and communicating. After using an MS4,MI996 to a value of $F4037 (It was $F4030 before when working) and saving and resetting, I cannot access it the drive through MACRO anymore. Using the MACRO ASCII setup does not see the drive. Starting right from a $$$*** and using MACRO ASCII setup in PEWIN32PRO2 fails to see the drive. I have a 24M2A and a 65M which can be communicated with but the GEOMACRO drive will not. The green MACRO light is illuminated and no errors are present but no ASCII communication available. 1. Can I reset it to factory defaults some how? 2. Can I access the I variables on the drive using the USB port on the front? I can open the port but how is it supposed to work? Straight terminal commands (if so I got no response) or PEWIN32PRO2? Thanks Matt Link to comment Share on other sites More sharing options...
MattReid Posted April 21, 2017 Author Share Posted April 21, 2017 Got it back on the line using a MACSTA0 to initiate ASCII communication and then issuing a $$$*** Link to comment Share on other sites More sharing options...
Recommended Posts