Jump to content
OMRON Forums

Using PowerPmacConfigLoad folder


DaveBarnett

Recommended Posts

Greetings, all...

 

We would like to use the USB stick/PowerPmacConfigLoad folder technique to allow users to update PowerPmac software in the field. This works nicely as advertised. However, we'd like to leave a couple motor settings *undisturbed* during the process.

 

We did the following:

 

Verified that using the flash drive with PowerPmacConfigLoad folder works as advertised. (worked fine)

 

Then, I edited the following two lines out of pp_custom_save.cfg (on the flash drive)

 

Motor[1].HomeOffset = 1234.01

Motor[2].HomeOffset = 3456.01

 

Re-inserted flash drive to PowerPmac…+ reboot

Now….after boot, we were hoping to see the two home offset values which were previously “saved” by user plc executing cmd “fsave” and the associated pp_custom_save.tpl file which looks like:

 

backup motor[1].servo

backup motor[2].servo

 

Motor[1].HomeOffset

Motor[2].HomeOffset

 

But…it didn’t work… instead, it seemed to use the last value which was written when we saved during IDE session with the terminal window.

 

Anyone know the right way to accomplish this??

 

Thanks !!

Link to comment
Share on other sites

  • Replies 0
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Guest
This topic is now closed to further replies.

×
×
  • Create New...