Jump to content
OMRON Forums

Power Clipper's multiplexed port protocol datasheet


RomanSolonto

Recommended Posts

  • Replies 5
  • Created
  • Last Reply

Top Posters In This Topic

You should be able to find something suitable that uses the 5 volt TTL I/O on either the JTHW or JIO port. For example, there is the Phoenix Contact PLC-OSC-24DC/300DC/1 relay. 32 of those should measure 198.4 x 86 mm (almost). I suggest checking with a vendor like that. Also, you could use a Modbus or Ethercat I/O device.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...