Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ACC-59 Dates missed in save configuration file
#1
If I try to save configuration with Setup Variables Tool in IDE all data except ACC-59 will be stored
Setup elements are visable if I call the tool. But there is only one channel selectable. Channels 1 to 3 are also missed.
On ACC-24 all channels are there.

IDE 2.2.1.25; Firmware 2.1.1.3 but same issue in older versions found.

Is there a possibility to store also setup data of the ACC-59 and see channels 1-3?


Attached Files Image(s)
   
Reply
#2
Can you view the other channels in the terminal or watch window?
Does the "System Setup" show all channels?
If this is the case there may be an issue with the "Setup Variables" window. I will look into this as a technical support issue.
Reply
#3
I had access to all channels in terminal and also in watch window.
In System Setup I can also find ACC-59. But here all channels are viewed together, so not necessary to select any channel.

If I try to select in plot window under "Detailed" tab it's also not possible to select other channel except channel 0. So in this case same issue as in "System Setup"

Regards
Wolfi
Reply
#4
The programmers will be fixing this shortly.
Reply
#5
Thank you Steve

Please held in mind biggest issue here is the missed dates in safed files from "Setup Variables"

Regards Wolfi
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)