Anil Posted January 19, 2017 Share Posted January 19, 2017 When PPMAC clipper is running, suddenly it stopped working. Upon checking at IDE, we got information in Error monitoring: "FileConfigErr" and also "PwrOnFault". And when we tried to Build and download project, Build and download happens. However when we give SAVE command in terminal, we get " Save did not complete. Check Sys WDTF & Log\pp_error_hist.log" file on the terminal. And in Show output from build window, we get "Could not upload the pp_custom_ save.cfg file from the Power Pmac.". After this we tried to reset($$$) or factory reset ($$$***) the clipper is not responding, and we get "Power PMAC Suit is Busy" LED indication: LEDs looks to be healthy. D10: Green, D12: No display, D15: Red after booting is over We don't know how to progress. Pl. help Link to comment Share on other sites More sharing options...
steve.milici Posted January 19, 2017 Share Posted January 19, 2017 The "FileConfigErr" could be a result of too many "hardware" clock configuration settings in a header file. Try using the USB stick to "factory reset the PMAC. See the attached document under "PowerPmacFactoryReset". Link to comment Share on other sites More sharing options...
illop Posted January 20, 2017 Share Posted January 20, 2017 Hi. I also experienced the same symptoms in PowerUMAC In my case, 1)Connect PowerUMAC throught micro-usb 2)delete userflsh folder or rename userflash folder 3) Copying the contents of userflash.1 to userflash 4) clear ^^ Link to comment Share on other sites More sharing options...
lovu Posted October 13, 2019 Share Posted October 13, 2019 Hello there, Anyone shows more detailed resons that directly cause Sys.FileConfigErr? It happened on my controller CK3E occassionally when powered up . Link to comment Share on other sites More sharing options...
steve.milici Posted October 15, 2019 Share Posted October 15, 2019 Hello there, Anyone shows more detailed resons that directly cause Sys.FileConfigErr? It happened on my controller CK3E occassionally when powered up . This is can also be the result of a corrupted project. Link to comment Share on other sites More sharing options...
lovu Posted October 16, 2019 Share Posted October 16, 2019 This is can also be the result of a corrupted project. Hi, steve. What do you mean by saying "corrupted progject"? I have done $$$***/save/$$$ before downloading my project. It's just a normal project with 14 ECAT slaves. Except for about 30 PVars in pp_custom_save.tpl, there is nothing else different in configuration folder. It occured sometimes and log file didn't show the reasons. I can find very few document describing this problem. Can you show me some detail? Link to comment Share on other sites More sharing options...
lovu Posted October 23, 2019 Share Posted October 23, 2019 Many thanks to Steve to help solving this problem. It is the fload command planned in my startup plc that corrupted Linux booting and it gets ok after delete it. Link to comment Share on other sites More sharing options...
tecnico Posted November 11, 2019 Share Posted November 11, 2019 Got the same problem, had to switch to a Capp that saves variables on the usrflash Still can't understand why there is no provision for retentive memory Link to comment Share on other sites More sharing options...
Recommended Posts